63-2
Before rebooting, the system checks whether there is any configuration change. If yes, it prompts
whether or not to proceed. This prevents the system from losing the configurations in case of shutting
down the system without saving the configurations
Use the following command to reboot the Ethernet switch:
To do…
Use the command…
Remarks
Reboot the Ethernet switch
reboot
[
unit unit-id
]
Available in user view
Scheduling a Reboot on the Switch
After you schedule a reboot on the switch, the switch will reboot at the specified time.
Follow these steps to schedule a reboot on the switch:
To do…
Use the command…
Remarks
Schedule a reboot on the switch, and
set the reboot date and time
schedule reboot at hh:mm
[
mm/dd/yyyy | yyyy/mm/dd
]
Optional
Schedule a reboot on the switch, and
set the delay time for reboot
schedule reboot delay
{
hh:mm
|
mm
}
Optional
Enter system view
system-view
—
Schedule a reboot on the switch, and
set the reboot period
schedule reboot regularity at
hh:mm period
Optional
The switch timer can be set to precision of one minute, that is, the switch will reboot within one minute
after the specified reboot date and time.
Configuring Real-time Monitoring of the Running Status of the System
This function enables you to dynamically record the system running status, such as CPU, thus
facilitating analysis and solution of the problems of the device.
Follow these steps to configure real-time monitoring of the running status of the system:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable real-time monitoring of
the running status of the
system
system-monitor enable
Optional
Enabled by default.
