Logging In Through NMS
Go to these sections for information you are interested in:
Introduction
z
Connection Establishment Using NMS
z
Introduction
You can also log in to a switch through a network management station (NMS), and then configure and
manage the switch through the agent module on the switch. Simple network management protocol
(SNMP) is applied between the NMS and the agent. Refer to the
SNMP-RMON
part for related
information.
To log in to a switch through an NMS, you need to perform related configuration on both the NMS and
the switch.
Table 2-11
Requirements for logging in to a switch through an NMS
Item
Requirement
The IP address of the VLAN interface of the switch is configured. The route between
the NMS and the switch is reachable. (Refer to the
IP Address Configuration – IP
Performance Configuration
and
Routing Protocol
parts for related information.)
Switch
The basic SNMP functions are configured. (Refer to the
SNMP-RMON
part for
related information.)
The NMS is properly configured. (Refer to the user manual of your NMS for related
information.)
NMS
Connection Establishment Using NMS
Figure 2-23
Network diagram for logging in through an NMS
Configuring Source IP Address for Telnet Service Packets
Go to these sections for information you are interested in:
Overview
z
Configuring Source IP Address for Telnet Service Packets
z
Displaying Source IP Address Configuration
z
2-35
