16
C
HAPTER
4: C
ONFIGURING
THE
V6000/V6100
Address
fields under IP Configuration to correspond with your network
IP settings.
Record and retain the IP address and subnet mask you assign the
V6000/V6100. Do the same when defining a new username or password.
5
Click
Reset Device
, and then at the prompt, click
OK
; the V6000/V6100
applies the changes and restarts.
6
Disconnect your PC from the V6000/V6100 or from the hub / switch
(depending on the connection method you used).
7
Reconnect the V6000/V6100 and your PC (if required) to the network.
8
Restore your PC's IP address and subnet mask to their original settings. If
necessary, restart your PC and re-access the V6000/V6100 via the
Embedded Web Server with its new assigned IP address.
Accessing the
Embedded Web
Server
To access the Embedded Web Server, perform these steps:
1
Open a standard Web-browsing application such as Microsoft
™
Internet
Explorer
™
(Version 6.0 and higher) or Netscape
™
Navigator
™
(Version 7.2
and higher).
2
In the URL field, specify the IP address of the gateway (for example,
http://10.1.10.10); the Embedded Web Server's
Enter Network
Password
screen appears, shown in
.
Table 2
V6000/V6100 Default Networking Parameters
Parameter
Default Value
IP Address
10.1.10.10
Subnet Mask
255.255.0.0
Default Gateway IP Address
0.0.0.0
