22
C
HAPTER
4: C
ONFIGURING
THE
V6000/V6100
Figure 8
Continuation of Trunk Settings BRI
6
From the Clock Master drop-down list, select the trunk clock source.
Choose either
Recovered
(the clock is recovered from the trunk =
default) or
Generated
(the trunk's clock source is provided by the
internal TDM bus clock source, according to the parameter
TDM Bus
Clock Source
).
7
From the ISDN Termination Side drop-down list, select
User Side
when
PSTN or PBX side is configured as
Network side
and vice versa.
8
Leave the parameter
BRI Layer2 Mode
at its default value.
In this release only P2P is supported.
9
To configure the different behavior bits, enter the exact hexadecimal bits
value in the field to the right of the relevant behavior parameter, or
directly configure each bit field by performing the following:
a
Click the arrow button (-->) to the right of the relevant behavior
parameter.
b
Modify each bit field according to your requirements.
c
Click the
Submit
button to save your changes.
10
After modifying the parameters:
■
To apply the changes to the selected trunk only, click
Apply Trunk
Settings
.
■
To apply the changes to all the trunks, click
Apply to all Trunks
.
