www.call4tel.com
Novelty Techpoint, Singapore 536212
+65 6340 1005
a. When the power source is connected, you will hear a short beep which means, the system is powered up.
b. When the system is started and ready, you will hear a long beep.
c. A long press on RST button for 2-3 seconds and release, will ensure the system is powered off. You will hear four beeps
as confirmation. The system is now successfully powered off..
d. For reset - a long press on RST for maximum 8 seconds until you hear ten rapid beeps, resets the
3CX phone system & network settings and auto reboots to a fresh installation. Proceed to use the default
IP address to access the setup interface.
e. If the 12V power is disconnected or there is a sudden outage, the UPS battery residing inside is automatically
triggered & executes the "
Power-off
" command to shut down the system safely, avoiding any data loss or system damage.
11
10
After update
Once the update is complete, you will be notified that “
Your device is up to date
”.
Additional Guide
Call4tel NX32 Detector
: To detect a connected NX32 device in your network,
click here
to download
http://update.call4tel.com/detector/NX32_DETECTOR.zip
