3
Cut 15mm sections of skewer and place into alignment holes in the fuselage sections.
NOTE
- It may be required to open up the holes a small amount if the fit is too tight. Do this
by using a 3mm drill bit. Gently spin it in reverse as you insert it into the hole. This will ensure
the bit does not tear the print.
Test fit the sections of the fuse before gluing to ensure a clean fit.
4
Glue all sections of the fuse together except fuse 1 and 4. Fuse 1 will be glued on last in
order to allow for cg balancing and Fuse 4 will be glued fitted after installing the elevator
drive gear.
5
Once glued, with a sharp knife, remove the false floor of the battery hatch. (refer section
marked in red)
NOTE
: The removed sections of LW-PLA that is the false floor will be used
as hinge pieces later.
Do not throw away.
