STANDBY
The modeler is in energy-saver mode. All internal subsystems
are partially cooled and the modeler is inactive.
None.
The modeler will warm to operating temperature when
you press any button or submit a build job.
WAITING FOR
JOB
The modeler is online, but there is no build job in it's queue. The
modeler is ready to build as soon as it receives a job.
Submit a build job to the modeler. Refer to
build job.
WARMING STAGE
[4,3,2,1]
The material heaters and printhead jet heaters gradually warm
up to either standby or build temperature.
None.
The numbers on the LCD panel count down as the
modeler warms up.
At
, all heaters and material are at
Warming Stage 1
build temperature.
11.0 Troubleshooting
If problems occur with the printer, error messages appear on the LCD of the Operator's panel. Refer to appropriate troubleshooting table for
assistance. There may be times when an unrecoverable error message will appear and will require a call to
contacting Technical Support Hotline ensure you have serial number of the printer, a brief description of the problem including exact error
message displayed on the LCD panel, and when the problem occurred (while submitting a job, during the beginning or end of the build, after
power off recovery, etc.)
11.1 Communication Errors
11.2 Head Maintenance Station Errors
11.3 Material Feed and Waste System Errors
11.4 Material Quality Guarantee Errors
11.5 Material Waste Errors
11.6 Motion System Errors
11.7 UV Subsystem Errors
11.8 Vacuum Regulator Errors
11.9 Power Outage
11.1 Communication Errors
MESSAGE
CAUSE
ACTION
RT_ERROR: No machine
Identification (ID)
No network
connection.
Ensure you have a valid network connection. Cycle power to the modeler. If error
message occurs again, contact your
evm6x_hpi_open()
A communication
error occurred.
Cycle power to the modeler. If this does not restore communication, contact your
Hotline.
evm6x_init_emif()
A communication
error occurred.
Cycle power to the modeler. If this does not restore communication, contact your
Hotline
11.2 Head Maintenance Station Errors
Summary of Contents for ProJet 5000
