Continue pushing the filament through the Teflon pipe till the end.
Using the dial go back to
Prepare
in the initial menu and turn it until
Move Axis,
click on
Advance
(in this case 1mm) and press again on the dial. Next, the selection of the axis
will appear on the screen and click on the
Extruder Field.
The value 0,00 will show, turn the dial clockwise seeing the value increasing while the
extruder drags the filament through the hotend, coming out through the nozzle as seen
on the lower picture. It is recommended to extrude 10mm minimum as soon as the
filament begins to flow through the extrusion nozzle.
CAUTION!! HIGH TEMPERATURE, DO NOT TOUCH ANY PARTS.
Summary of Contents for ILC
