8.8 Marks on the top side
This happens when you see grooves in the filling of the upper faces. The possible causes
are:
Very High Extrusion Flow: Please refer to the
8.4 Over
Extrusion
. The effect of the hotend’s heat while moving
over the already printed layers. If the displacement
strategy is done inside the same layer and the filling comes
out irregularly, geometrically speaking, the hotend can
travel through the already printed surface leaving marks
on it because the heat effect. To avoid it, go to “LIFT Z” in
Slic3R
and “Z HOP” in
CuraEngine
where you can lift the Hotend during the
traveling without extrusion, going back to the original position when it is
necessary to continue the extrusion.
Slic3R
Printer Settings Tab - Extruder 1 – Option: Retraction - Lift Z
Summary of Contents for ILC
