•
Indoor use
•
Altitude of operation: <2000m
•
Operating temperature: 5-
40ºC
•
Relative humidity: 20-80% (up to 31ºC), decreasing linearly to 50% at
40ºC
•
Pollution degree of the environment: Pollution degree 2
The Allevi 3 should be stored in the following conditions:
•
Temperature: 5-
40ºC
•
Humidity: 20-
80% (up to 31ºC), decreasing linearly to 50% at 40ºC
•
WARNINGS
•
The Allevi 3 includes moving parts that can cause injury. Never reach inside the printer while it is
in operation.
•
Do not leave the printer unattended while it is in operation.
•
Always wear safety goggles when using the printer.
•
Do not mount the Allevi 3 on or near a surface of flammable material.
•
There are possible hazards of explosion, implosion, or the release of toxic or flammable gases
arising from materials being heated.
•
If you are working with hazardous materials, you should set up the appropriate extraction system
and/or ventilation requirements.
•
You are responsible for appropriate decontamination in case of spillage of hazardous materials
on or inside of the equipment.
•
If the equipment is used in a manner not specified by Allevi, the protection provided by the equip-
ment may be impaired.
6
Allevi 3 | User Guide
ENVIRONMENTAL CONDITIONS
The Allevi 3 should be operated in the following conditions:
MAINTENANCE AND CLEANING INSTRUCTIONS
•
Recommended decontamination is spraying with 70% ethanol while the printer is powered down,
turning your hood fan on for 30 minutes, and wiping down the printer after at least 10 minutes.
Additionally, 30 minutes of UV decontamination may be used to supplement the ethanol wipe down.
•
Do not over-spray ethanol directly into the electronics of the Allevi 3. Spray a towel, then wipe the
printer down with the towel. Do not use decontamination or cleaning agents which could cause a
hazard as a result of a reaction with parts of the equipment or with material contained in it.
SERVICE INSTRUCTIONS
Allevi bioprinters should be serviced by Allevi or Allevi-certified personnel.
To request servicing, email
support.allevi3d@3dsystems.com
Summary of Contents for Allevi 3
