21
3D Systems, Inc
.
4 . Pull out 12”/30 cm of material from the cartridge . Select the
checkmark
to
continue .
5 . Cut off 2”/5 cm of material from the end . Select the
checkmark
to continue .
NOTE: Ensure the material is not bent or creased . If the material is
not straight, pull out the damaged material from the cartridge . Cut
off and dispose the portion that is not straight .
6 . Insert the material
under the clamp roller
and into the material tube . Select the
checkmark
to continue .
7 . Gently push the print material into the print jet until molten plastic jets into the jet
wiper . Select the
checkmark
to continue .
NOTE: When the material reaches far enough into the print jet area,
a motor will assist with feeding the material into the print jet .