72
3D Systems, Inc
.
5 . Insert the mass storage device into the CubePro USB inlet port and select
.
6 .
Navigate to the calibration file and select
.
NOTE: The filename may differ from the illustration.
NOTE: The printer may require you to install additional cartridges
or replace a cartridge . Follow the instructions on the screen and
refer to the section titled
Unpacking and Setting Up Your CubePro
.
7 .
Once the printer has finished printing, remove the print pad from the printer and
inspect the scales . If adjustments are required, proceed to the next step . If the
scales are aligned properly, no further action is required .
8 . Navigate to the
Print Jet Calibration
screen and select
OFFSET JETS
.
9 .
Since the file has already been printed, select the
checkmark
to continue .