REMOVING YOUR CREATION FROM THE PRINT PAD
Before you attempt to remove your creation from the Print Pad, please ensure that the CubeX has finished
printing and that the Print Pad has moved to the bottom of the CubeX.
1 . Lift the Print Pad from the side and pull up to remove the Print Pad from the
CubeX .
2 . Submerge Print Pad and the base of the part in warm water for five minutes.
(Fig . 92) If you do not have the ability to submerge the Print Pad place Print Pad
in sink and let hot water run over the base of the part for about 5 minutes .
REMOVING RAFTS
A raft is the flat support structure that is attached to your creation. Though we recommend printing without a raft, some larger
or more complicated parts may require one . If you print with a raft, the following instructions will help you remove it:
REMOVING SUPPORTS WITH WIRE CUTTERS
Use wire cutters to cut away the support structure from your model . You should cut the supports at the point where they
touch the model .
FINISHING YOUR CREATION
!
Fig . 92
Fig . 93
ABS RAFT / PLA PART - PLA RAFT / ABS PART
ABS rafts can be peeled away from PLA parts .
ABS RAFT / ABS PART - PLA RAFT / PLA PART
Use pliers to pull away as much of the raft as possible .
Then use a rough-grade sandpaper to remove the
remaining raft, followed by a fine-grade wet and dry
sandpaper to achieve a smoother finish.
26
3 . Using the scraper (included in tool kit), gently release your creation from the
glass . (Fig . 93)
4 . Rinse your creation under hot water to ensure all of the Magic CubeX Glue paste has been removed .
5 . To clean the Print Pad, rinse the pad under hot water to clean off any remaining Magic CubeX Glue paste .
6 . Dry the Print Pad thoroughly before reinstalling it into CubeX .