Fig . 121
15 . Plug the USB stick into the CubeX 3D Printer and press the control button; you will receive
a notification of your settings being restored. (Fig. 121)
Fig . 122
Fig . 123
16 . Your firmware has now been upgraded. (Fig. 122)
RESTORING THE SETTINGS YOUR CUBEX PRINTER FIRMWARE FROM V1.01
Before following these instructions, please follow instruction 1-9 in the section UPGRADING YOUR CUBEX PRINTER
FIRMWARE .
1 . Turn on the CubeX 3D Printer . You will see the activation screen .
2 . Re-activate your printer using your activation code . (if you do not have your activation code, you can locate it be going
to
Cubify.com
>
MY ACCOUNT
>
MY DEVICES
and then viewing your registered CubeX) .
3 . Once it is re-activated turn off the CubeX 3D Printer .
4 . Plug the USB stick into the CubeX 3D Printer and turn it on, touch the screen and you will receive a notification of your
settings being restored .
5 . Your firmware has now been upgraded.
HOW TO CONTACT CUBIFY SUPPORT
If you have any problems with your CubeX that cannot be solved using this manual, please contact
cubifysupport@cubify.com
for your support related issues .
SETTING THE CUBEX PRINT JET OFFSETS
CAUTION: Do not use the offset menu unless you have
been advised to do so by Cubify Support, as changes to
this may affect the quality of multi-material prints.
!
34