3D Systems, Inc.
24
p/n: 15-D100, rev. D
12
10
9
11
8
PC ON
: the PC ON button is used to switch the machine PC ON and OFF.
Door bypass
: this key is reserved for service personnel only. It will override the electrical cabinet interlocks so the
Certified Service Engineer is able to work inside the electrical cabinet while the main power switch is on.
24V DC On/Off (printer only)
: the power switch for all components in the DMP Flex 350 printer with the exception
of the PC, PC monitor, printer blower, printer blower fan, vacuum pump, network switch printer and the lights in the
electrical cabinets.
Enable switch
: this switch is reserved for Certified Service Engineers only and allows them to perform specific
maintenance operations.
WARNING: THE ENABLE SWITCH MUST REMAIN CONNECTED AT ALL TIMES. IF NOT, THE MACHINE WILL GO INTO
EMERGENCY OFF STATE.
Main argon valve - Main compressed air valve
: these knobs will open/close the argon and compressed air supply
to the DMP Flex 350 system. In case of a Lock Out-Tag Out (LOTO) procedure, close these knobs to shut off the main
argon/compressed air supply. Closing these valves will also release any residual pressure in the tubing of the DMP Flex
350 system.
8
9
10
11
12