3D Systems, Inc.
44
p/n: 15-D100, rev. D
4.5 DMP Deposition - Operator
DMP deposition is used for preparing the printer before a print job, checking sensors/actuators and doing
maintenance. While printing, this program controls all movements, sensors and vacuum cycle.
DMP Deposition is build up out of the following parts:
4.5.1 Oxygen/Pressure Status
This window in the top right corner of the screen shows the
current oxygen level. The displayed unit will be in % while the
chamber is at high oxygen content and will switch to ppm
(parts per million) when the oxygen content gets below 1%.
This will be shown as soon as the printer starts preparing to
print.
Next to the oxygen level, the relative pressure in the process
chamber (in millibar) is shown. A negative number means
there is underpressure, a positive number means there is
overpressure.
4.5.2 Machine Status
This window shows:
• the current status of the machine
• the powder type currently loaded in the machine
• the powder batch number
• a log of all events that occurred on the machine