3D Systems, Inc.
45
p/n: 15-D100, rev. D
4.5.3 Menu Bar
A. File
•
Exit: Click to close down the DMP Deposition software.
B. Controllers
•
Test signal tower lights
: Click to open the window to test
the lights in the stack light. Use the check boxes to switch
the lights on/off. When the window is closed, the light
stack will go back to its original state.
•
Verify if ready for processing
: Click to verify if the DMP
Factory 350 is ready to start a job. During this cycle a set
of parameters will be checked to see if the system is fully
prepared to start a print job.
•
List PLC details
: Click to open a pop-up window with details
on the PLC used in the system.
•
List safety PLC details
: Click to open a pop-up window with
details on the safety PLC used in the system.
•
Run filter prepare cycle
: Click to open the
Bring filter to a
safe state
pop-up window. Click
Start
to bring the filter to a
safe state after it has been replaced or after a long period
of inactivity. Click the check box
Combine with machine
preparation cycle
to start a preparation cycle immediately
afterwards.
•
Touch behavior
:
• Select
Optimized for mouse
when working with a
mouse connected to the pc through one of the USB
ports on the printer control panel.
• Select
Optimized for touchscreen
when working only
via the touchscreen.