3D Systems, Inc.
49
p/n: 15-D100, rev. D
1 2
3
4
5
6
Click the icons shown above to access the following menus:
• Manual:
manually control the machine and perform actions
• Run Job:
window that will be shown during printing
• Maintenance: opens up the Maintenance tasks module
• Message:
opens up the User Message screen
• Light:
will turn on/off the light inside the process chamber
• Actuators:
will open up the Actuators window
• Sensors:
will open up the Sensors window
• Protect:
will open up the Protect window
4.5.4 Tabs
A. Manual Operation
Click the tab
Manual
to open the Manual operation.
Coater Movements
1. Move coater to left end position
2. Move coater left until button is released
3. Move coater to middle left (only available when coater is left of the build platform)
4. Move coater to middle right (only available when coater is right of the build platform)
5. Move coater right until button is released
6. Move coater to right end position
In the task bar, click the
Manual
button to open the
Manual operation
window.