3D Systems, Inc.
61
p/n: 15-D100, rev. D
4. Lower the build platform until the top of the build plate
matches the exact height of the module. Use a straight
edge, e.g. the spatula, to check the height.
5. Open the
Manual
tab and click the
Manual
button.
6. Use the arrows in the
Manual operation
screen to adjust
the height of the build plate.
5.2.3 Install New Coater Strip
1. Move the coater to the center of the build plate. Press
and hold the
Hold-to-run
button on the control panel of
the printer and click the coater movement buttons in the
Manual Operation window.
Caution: Keeps hand clear of the process chamber
during this operation.
2. Remove the recoater housing from the recoater bridge by
releasing 2 bolts.