3D Systems, Inc.
62
p/n: 15-D100, rev. D
3. Loosen 6 Allen head bolts.
4. Place new silicone strip in the recoater housing. Tighten all
the bolts from one side to the other and ensure the silicone
strip is fixed.
5. Place the recoater housing in the lower part of the coater
cutting tool. Place the upper part of the coater cutting tool
on top.
1
6. Use a sharp utility knife to cut the recoater in one smooth
motion.
WARNING: BE CAREFUL WHEN CUTTING THE
RECOATER. THIS PRESENTS A CUTTING DANGER.
7. Leave the recoater housing in the upper part of the coater
cutting tool and cut the ends of the silicone strip where
they stick out of the recoater housing. Cut the corners at
a 45° edge. Check if the silicone strip is smooth with no
irregularities. If the recoater is not smooth, use a new
silicon strip and cut it again, repeating Steps 2-5.
8. Re-attach recoater housing to recoater bridge.