3D Systems, Inc.
68
p/n: 15-D100, rev. D
11
1
2
3
4
5
5.4 Start Job
1. In
DMP Control
, click on
Job analyser
.
2. Click on
Single Layer
(1) and
Power Burn
(2).
3. Click on
Start Job
(3).
4. The printer will scan the first layer to the plate, make sure
all the parts are on the build plate.
5. In
DMP Deposition
, open the
Manual
tab and use the
controls to lower the build plate 20μm and use the coater
to deposit a new powder layer over the build plate (4).
6. Make sure
Single Layer
and
PowerBurn
(5) are no longer
on. You can now start the job from layer 1 and the printer
will start with the direct metal printing process.