3D Systems, Inc.
18
Material Storage
Build Material
Support Material
Shelf life for VisiJet Build Materials with the
exception of HiCast & ProWax - 2 yr
Shelf life for VisiJet HiCast & ProWax - 5 yr
Shelf life - 5 yr
Climate - Cool, dry area with adequate venti-
lation
Climate - Cool, dry area with adequate ventila-
tion
Temperature Range - 60°F (16°C) to 80°F
(27°C)
Temperature Range- 60°F (16°C)to 80°F
(27°C)
Maximum Storage Temp - 95°F (35°C)
Maximum Storage Temp - 95°F (35°C)
Environmental Conditions - No direct sunlight,
heat, flames, or UV energy.
Environmental Conditions - No direct sunlight,
heat, flames, or UV energy
NOTE: For optimal results, keep stored cartons closed and sealed until material cartridges are ready for use.
•
Always check material “Recertification Date” before use. Do not
load material cartridges into printer if cartridge date has expired .
When printer detects an expired cartridge, it aborts the build and
rejects the cartridge .
•
Support (white) material must be loaded in the left side of material
drawer . VisiJet part (black) material cartridges must be loaded in
the right side of material drawer . Before loading cartridges into
printer, inspect the cartridges for signs of damage or leakage . Do
not load a damaged or leaking cartridges . Dispose of material
cartridge according to local regulations .
Storing a Partially Used Material Cartridges
•
It is important not to lay material cartridges that are partially used on their
side . Doing so will cause material to seep through the vent cap and clogging
cap . This will cause damage to the material cartridge if used for a later build .
•
To store a partially used material cartridges, insert cartridge into a plastic bag
with the vent cap up; place cartridge into its original shipping carton’s sleeves
and carton . Do not remove a partially used Support Bottle from the MDM if
the MDM is NOT heating; the material will solidify and cause a breakage .