33
3D Systems, Inc.
PRINTER SET-UP and OPERATION
14
NOTE: Power up the printer
This section will briefly introduce you to using 3DPrint
®
to prepare your part for building. It will then show you how to get your ProJet
®
4500
ready and actually print your part. For all the details on using 3DPrint
®
, refer to the
3DPrint
®
User Manual
.
WARNING:
Read and follow safety guidelines in Electrical Safety. Ignoring these guidelines could result in death,
bodily injury, or printer damage due to electrical shock or fire.
CAUTION:
Verify printer’s rear panel power switch is OFF. Connecting power with switch on can damage printer
and cause bodily injury or death due to sudden, unexpected mechanical motion.
PREPARE THE BUILD AREA
Go to your printer and check each item listed below to ensure the printer is ready to print. It is important to check each of these items
before every build.
1. Check that the
Deck
,
Fast Axis
, and
Build Bed
are clean of any loose core material. Vacuum any ex-
cess core powder from the surface.
2. Check that the
Debris Separator
is empty and cleaned
of excess powder.