35
3D Systems, Inc.
PRINT THE BUILD
NOTE:
Please refer to the
3DPrint
®
User Manual
.
6. Check that the
platform
is raised to the top of the Build
Chamber or “
to the top of its travel
.”
7. Select
PREP BUILD CHAMBER>CONTINUE
on the
LCD
menu to raise the platform to its proper position..
CURING THE PART
When your part is finished printing, the printer runs a heat cure cycle. Heating will begin during the build and continue after the build is
complete.
A timer on the LCD menu will count down the time remaining to cure the part. Curing the part is required for strength development and to
fulfill health and safety requirements.
If parts are uncured, they will make it through the Debris Separator. Do not vacuum uncured parts with the user hose.
[NOTE: Do not open the door during the printer’s “drying” cycle. The overhead lamp will be cycling during this time and can
pose a danger due to excessive heat.]