36
3D Systems, Inc.
CLEAN THE PART
Once your part has dried, you will need to clean it to remove any remaining loose Core material. Cleaning is done in two stages: “coarse”
cleaning, which removes the Core material around the part in the Build Bed; and “fine” cleaning, which removes any Core still clinging to
the part itself. Do not vacuum uncured parts. Run a cure cycle from the Utilities menu before vacuuming.
Coarse Cleaning
Your part prints and dries in the
Build Bed
surrounded by unused, loose core. You will need to remove unused core from the Build Bed
after the drying cycle is finished.
Important
: Use caution when removing and cleaning. T
1. Before you begin vacuuming, check the part orientation in 3DPrint to
avoid damage to your part.
2. On the LCD display, select
VACUUM
.
3. Open the printer top cover. The vacuum starts. Use the
Control Knob
to
move the
Build Platform
up as you vacuum. Unused Core that is vacuumed
from the
Build Bed
is recycled back into the printer feeder so it can be used
for future builds.
NOTE: Gloves, eye protection and sleeve protectors are required dur-
ing depowdering.