9
3D Systems, Inc.
GENERAL SAFETY GUIDELINES
The printer is designed with built-in safety features, improper use and malfunctions can cause injury to personnel. To prevent unsafe
operation, the printer will automatically shut down if unsafe conditions are detected.
Follow these safety guidelines when operating the printer:
•
Do not ignore warning signs posted during printer service operations.
•
To prevent potential skin-irritation and sensitization due to contact with material, follow all guidelines within Build Material Safety.
•
To prevent pinch and crush injuries to the hand, use caution when replacing platform inside the build chamber.
•
Use caution when touching the top of the printer as the curing lamp can cause the top of the printer to become hot.
DANGER:
Hazardous voltage exists inside the printer. Injury or death from electrical shock can result if you remove the
printer’s external panels. Panels should only be removed for service by trained and certified 3D Systems Technical Support
personnel or your certified service reseller.
To prevent electrical shock, the printer will not operate unless external panels are installed. Check the facility’s electrical ser
-
vice rating before you connect power to the printer.
ELECTRICAL GUIDELINES
•
Read and follow all printer instructions.
•
Follow all safety rules and heed all cautions and warnings in this guide.
•
Do not attempt to open chamber door while build in progress.
•
Do not use any material without reviewing the Material Safety Data Sheets/Safety Data Sheets (MSDS/SDS).
•
Dress power and communication cables behind printer to prevent tripping.
•
Do not attempt to access, service, or adjust printer components. Do not attempt to perform any maintenance procedures unless
specifically trained to do so.
•
Operators should be trained to operate system and perform all necessary tasks to create a part.
•
Certified service personnel are those who completed the 3D Systems service training package and certified to perform service
tasks. Certification may occur at different levels, and service providers should only perform tasks they are authorized and certified
to complete.
•
Do not ignore warning signs posted during printer service operations.
•
If an error message appears on the printer’s LCD refer to “Error Messages” within this guide before resuming operation.