3D Systems, Inc.
9
Chiller
Supplied by
: SMC (Model: HRS024)
Installed by
: 3D Systems
The SMC chiller ships with the system . It requires a separate, single-phase power
source and a coolant hose kit .
See
Chiller Requirements on page 20
for chiller electrical and clearance
requirements as well as the OEM literature which accompanied your unit .
Use the chiller specifications and purchasing information in this section if you
choose to purchase your chiller from a supplier other than 3D Systems .
NOTE: The chiller requires coolant to run. Be sure to have sufficient
coolant (distilled water and OptiShield) on hand when 3D Systems
comes to install the system . See
Chiller Coolant Requirements on
page 20
.
Nitrogen Generator
Supplied by
: 3D Systems (P/N 104011-02)
Installed by
: 3D Systems
3D Systems manufactures a High-Performance Nitrogen Generator .
The generator is ideal for SLS applications .
See
Nitrogen Requirements on page 21
for nitrogen supply
equipment specifications.
Part Transfer Tray
Extraction Cylinder
Part Transfer Cart
Supplied by
: 3D Systems (P/N 134
1
01)
Installed by
: 3D Systems
The print cake Extraction Cylinder, Part Transfer Tray and Part Transfer Cart, are used
to remove the print cake from the ProX 500 print chamber and transport it to the MQC
System . The system ships with the cylinder and tray . The transfer cart is optional .
Part Transfer Cart
3D Systems
Nitrogen
Generator
Compressed
air inlet
O
2
exhaust
N
2
outlet
