3D Systems, Inc.
12
p/n 76-D022 Rev. A
The following items are consumed at varying rates during the SLS process:
•
Nitrogen
•
SLS Materials
•
Filters
These items are described separately in the sections that follow .
•
Contact 3D Systems to purchase replacement SLS materials and filters.
•
See your nitrogen supplier to replenish stocks of this item.
NITROGEN CONSUMPTION
NOTE: Your site’s actual nitrogen consumption may vary from the nitrogen consumption estimate below .
One ProX
®
SLS 6100 3D Printer system will consume approximately 140 cubic meters (4944 cubic feet) of nitrogen gas per week .
This estimate assumes seven days of continuous operation (24 hours/day) with seven purge cycles (one per day) .
NOTE: This volume estimate is for gaseous nitrogen—not liquid nitrogen . Be sure to ask your supplier for the
proper liquid-to-gas volume conversion ratio so you can properly size your tanks .
SLS MATERIALS
The material listed below is available for purchase from 3D Systems . The material comes with its own 3D Systems Material
Guide to help you use it successfully .
•
DuraForm™ ProX PA
•
DuraForm™ ProX AF+
•
DuraForm™ ProX FR1200
•
DuraForm™ ProX GF
•
DuraForm™ ProX HST
•
DuraForm™ ProX EX Black
Refer to your
Material Guide
for further information .
REPLACEABLE FILTERS KIT
The process station and chiller have customer-replaceable filters. 3D Systems recommends you keep a supply of these filters on
hand and replace them when necessary to ensure part quality and trouble-free operation . 3D Systems sells a kit containing a
year’s supply of filters.
FILTER KIT (P/N 132562-00)
Laser Power Supply Filter
EPM Filter, Pleated
EPM filter, Charcoal, Pleated
Seal, HEPA Filter
Filter, HEPA
Filter, 2-stage, 5u (Sock)
Electrical cabinet filters
CDA Filter on pressure regulator
NOTE: Filters are also replaced as necessary by your 3D Systems Field Service Representative during scheduled
preventive maintenance visits .
5
CONSUMABLES