3D Systems, Inc.
4
p/n 76-D022 Rev. A
10 . Slowly lift the printer several inches until it is cleared from
the pallet .
11 . Slide the pallet away from under the printer as shown .
12 . Slowly lower the printer to the floor.
13 . Roll the printer to the desired destination .
NOTE: If recrating the printer, please use the
instructions in reverse order .
14
.
Once the printer has been rolled into the desired location,
secure the printer using the (4) casters by raising the cast-
ers onto the leveling feet . At this point the printer is stable
for operation, testing and service .