3D Systems, Inc.
13
p/n 76-D020 Rev. A
MATERIAL SAFETY
All materials certified by 3D Systems are safe during normal operation. However, you should be aware of the following issues:
•
Any material, material-like substance, or airborne cloud of material has a remote chance of rapid combustion .
•
Breathing some materials may cause certain people to experience respiratory irritation .
•
Material safety hazards are minimized by good industrial housekeeping and ventilation practices .
•
Spilled material can cause the floor to become very slippery.
•
Material should be sifted in a well-ventilated room .
Refer to the SDS’s and to 3D Systems material guides for information on specific materials.
CAUTION: Using materials that have not been certified for use in the SLS equipment may cause health or safety
hazards and may damage the equipment and void the warranty .
Material Ignition Information
Powdered materials can be flammable and can be ignited by static electricity in a non-inert environment. Refer to each
material’s SDS for specific information.
CAUTION: The operator must use an approved vacuum cleaner to clean up excess material . 3D Systems
recommends an ESD or explosion-proof model . Contact 3D Systems Customer Service for purchasing options .
Finding Material Safety Information
Use the Material Safety Information table to locate references and contacts for information on important material safety topics .
Also check the SDS of the material used for the specific precautions to be observed.