3D Systems, Inc.
25
p/n 76-D020 Rev. A
Adding and Deleting Parts and Other Changes
Click the
Add/Delete Parts
button in the Build Modify dialog to launch the 3D Sprint application . From here you can modify
most aspects of your build packet during the build .
The application works just as described in the 3D Sprint Help, except that it also displays a plane marking the current Z level.
Changes you make below the plane, such as adding or moving parts, will not affect the current build, although they will be
saved and will affect future runs of this build packet .
Running a Prime Cycle
The Prime Cycle can only be run if the user has paused the build .
Click the
Prime Cycle
button in the
Build Modify
dialog to
spread powder across the print bed without moving the part piston, which can compensate for a short feed .
When a Build Ends
At the end of a build, the Sinter application displays a summary of the actual build times such as the example below: