3D Systems, Inc.
38
p/n 76-D020 Rev. A
CLEANING AND REPLACING FILTERS
There are several filters on the ProX SLS 6100 and MQC System that need to be cleaned or replaced periodically. It is suggested
that each of them be checked weekly and replaced as necessary:
ProX SLS 6100 Filters
•
Air Processing Module Filter
•
Transport Filter (“Sock” Filter)
•
Electrical Enclosure Filter
Particulate Filter
Active Charcoal Filter
Air Processing Module
1 . Open the top back doors of the printer .
2 .
Unscrew the filter cover.
3 .
Remove the filters and clean them using a vacuum cleaner or cloth, or, replace them with new filters.
4 .
Replace the filter cover.
5 . Close the printer doors .
Exhaust Processing Module Filters
Tools and Supplies
•
Tack cloth
•
New filters
•
Non-Ignition vacuum cleaner
The exhaust processing module filters gas moving through the print chamber. You access these filters from the back of the
printer by loosening the thumb screws and removing the panel .
To clean or replace the filters: