3D Systems, Inc.
39
p/n 76-D020 Rev. A
Transporter Filter (“Sock” Filter)
Tools and Supplies
•
Tack cloth
•
Non-Ignition vacuum cleaner
•
New filters
Cleaning or Replacing the Transport Filter
The transport filter filters powder and air moving through the
system . There is one located at the rear of the ProX MQC Single
Use System and one on the left side of the printer . You access
the filter by loosening the thumb screws and removing the
cover .
To Clean or Replace the Filter:
1 . Open the right-lower door of the printer or rear door of the
ProX MQC System .
2 .
Loosen the top thumb screws to unclamp the sock filter.
3 .
Remove the sock filter.
4 . Turn inside-out, shake off loose powder, and vacuum .
5 .
If necessary, replace the filter.
6 .
Replace the filter cover.
7 . Close the printer door .
Electrical Enclosure Filter
Electrical Enclosure Filter
Sock Filter
“Sock” Filter
Electrical Enclosure Filter
Tools and Supplies
•
Tack cloth
•
New filters
•
Non-Ignition vacuum cleaner
Replacing Electrical Enclosure Filter
Air moving through the electrical cabinet is filtered from
both sides of the cabinet. You access these filters by
loosening the thumb screws and removing the covers .
To replace the filter:
1 . Open the lower door (left or right) of the printer .
2 .
Unscrew the filter cover.
3 .
Remove and replace the filters.
4 .
Replace the filter cover.
5 . Close the printer door .