3D Systems, Inc.
4
p/n 76-D020 Rev. A
ProX® SLS 6100 SYSTEM COMPONENTS
ProX® SLS 6100 User Interface
The User Interface, located on the front panel of the printer, consists of a monitor and the system status LED indicators . An
E-Stop is located above the touchscreen .
B
C
A
User Interface:
The user controls the system using a keyboard
and pointing device located below the monitor .
Emergency Stop:
This switch, located above the monitor,
immediately disables all hazardous machine functions or renders
them safe . However, some surfaces may remain hot and care
should be taken when handling them . After being pressed, it
remains in the closed state until it is manually returned to the
open state
Buttons, Indicators, USB Ports:
Chamber Lights:
This button turns the chamber lighting on or
off
LED Indicators:
The LED indicators under the monitor indicate
the system’s power and safety status . Each indicator operates as
follows:
• “
Laser
”
Blue LED
-
ON
, Solid
»
Laser is enabled .
-
OFF
»
Laser is not enabled .
• “
Control
”
Green LED
-
ON
, Solid
»
System is on and its controller has initialized .
»
The system is in
RUN
mode .
-
OFF
»
System is
OFF
or its controller is still initializing .
• “
System
”
Amber LED
-
ON
, Solid
»
All E-stop buttons are reset, and system power is
enabled .
-
OFF
»
An E-stop button is pressed or system power is not
enabled .
System Enable:
This button re-enables the system following an
emergency stop, which occurs after the emergency stop switch
returns to the open state .
USB:
There is one standard auxiliary USB port connected to the
control PC . It is located under the LED Indicators .
A
B
C