3dscentral.3dsystems.com
17
1.
Place paper towels
around the Service Sta-
tion, and between the
Service Station and the
Build Bed.
2.
Cover the front overflow
with paper towels.
3.
Position the squirt bottle
close to the station and
squirt water on and
around the squeegee.
4.Use the cotton swabs
or a paper towel and
wipe the front and back
of the squeegee. Use
the Pick to scrape
excess powder out of
any corners.
5.
Remove the spit plate
from the Service Station
and clean it with a paper
towel. Replace the spit
plate, using the edge tabs
for correct alignment.
6.Install a needle onto the
small syringe. Gently push
the tip of the needle
through each of the six
Wash Holes to clear them.
7.Wipe off any water or
wash fluid on the Wash
Holes. Thoroughly wipe
the Service Station clean.
8.Wipe up any water that
may have spilled onto the
Deck or Build Bed.
9.
Remove the paper towels from the Front Overflow and dry it
thoroughly.
10. Close the printer top cover.
