Assembly 3Dfeedy » Connect Drive Gear to Extruder Drive Motor
Version 1.0
14 von 25
ASSEMBLY 3DFEEDY
Now 3Dfeedy is ready for marriage:
1.
Connect Drive Gear to Extruder Drive Motor
i
You may use the extruder drive motor from your 3D-printer uninstalled in chapter “Preparation
3D-Printer”.
i
Alternatively, a new extruder drive motor can be bought and used for further steps.
If a new extruder drive motor was bought, make sure it has equal settings to your extruder drive
motor for not damaging the mainboard of your 3D-printer.
•
Connect the drive gear from the box to the extruder drive motor by pushing it on the shaft if
necessary.
i
Take a close look at the flat shaft of the extruder motor drive to correctly align and connect the
drive gear.