Assembly 3Dfeedy » Insert Selector Shaft
Version 1.0
17 von 25
4.
Insert Selector Shaft
•
Insert the selector shaft to 3Dfeedy.
Be careful when inserting the selector shaft for not damaging the housing at the transmission
unit!
•
After inserting the selector shaft carefully rotate it slightly to fit the highlighted area of the
selector shaft to the drive gear.
•
If there are collisions when inserting the selector shaft, the components on the shaft may be
slipped and have to be repositioned during insertion.
•
Try to rotate the manual adjustment wheel until the selector shaft starts to rotate.
i
Slightly press in the selector shaft at the bearings to avoid it from pushing out.
i
If the selector shaft starts to rotate, the selector shaft is correctly oriented.
i
If the selector shaft does not start to rotate and the selector shaft is pressed out even though it
is fixed with your hands, the selector shaft is probably wrong oriented and the step marked in
violet should be repeated. This can usually also be seen when the bearing does not fit at all in
the groove.