3DCPI-02
START-UP GUIDE
6.
Clic “Merge” button. G-code Generation dialog boxes pop up. See Figure 7.
7.
Generate G-code one by one. Two data files will be merged into a.gcode file.
Now, print from SD card or computer, referring to single-extruder machina
operation.
Setting up the Printer
1.
Utilities->Extruders 2 (Press the center button to select this menú. Use up and
down arroz keys tos et number. Press the center button, when the number is 2.
The left arroz allows you to go back to main interface.)
2.
NOTE: This step is to select two extruders. Preheat->Stara preheat->Right Tool
ON, Left Tool ON (The left arroz allows you to go back to main interface.)
3.
NOTE: After selecting Right/Left Tool ON, the corresponding extruder will be
heated.
Utilities->Filament Loading->Load Left (When the left extruder reaches the
temperatura, insert filament to it. Press the center button to stop loading, as plastic
Stara comino out of the nozzle.)
4.
Referring to step 3, load filament to right extruder.
How to Change Speed & Temp When Building
1.
The screen is shown as below (Figure 1) when building. Press the center button
to navegate menu.