27
4.14.
SOFTWARE ERRORS
This section describes the most general errors, which could occur during the
extrusion process. If none of
the steps below seems to concern your extruder’s
situation. For additional questions, please contact us via
Error name
Information
"The external supply voltage
is too low or absent."
This occurs when only the USB-cable is
connected or none at all. Please turn on the
mains electricity o
f the extruder with the ‘On’
button on the back and check the power
cable.
"Reset signal received."
This message is shown when the
USBconnection is opened on the PC. This
reset is necessary for us to upgrade the
firmware.
"Extruder motor too hot."
This occurs when the extruder motor has run
to hot due to too much friction generated by
the screw or extruding for a very long period
with high RPM settings.
"Extruder motor current
limit reached."
This occurs due to too much friction
generated by the screw. The temperature
settings might not be correct.
"Positioner endstop hit
unexpectedly."
End-stop hit by user or with the positioner.
"Hopper is empty for too
long."
This occurs when the hopper sensor detects a
low amount of granulate in the hopper.
