PANNORAMIC® SCAN RX 1.1
OPERATING SLIDES AND MAGAZINES
NOVEMBER 18, 2021
33
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
3.3
Inserting and removing slides
To insert slides into a magazine
Figure 8: Inserting slides into a magazine
Caution!
Incorrect slide insertion may break the glass. Always make sure that slides are correctly
inserted in the tray. The edge of the broken area of the slide is sharp and its removal can
lead to injury and contagion! Broken slide can be removed only by a well-trained person!
A magazine can contain a maximum of 25 slides.
•
Push slide
(1)
into the magazine
(3)
with its barcode end
(2)
first. The symbols on the side
of the magazine demonstrate the proper way of inserting slides.
Notice:
You should insert several slides into a magazine without empty slots. Begin the insertion on
position 1 of the magazine.
Caution!
Only original 3DHISTECH magazines are allowed for use with Pannoramic® SCAN RX! To
insert or remove a filled magazine from the device, or when transporting it, slightly tilt it to
its closed side to prevent the slides from accidentally falling out. Magazines should always
be kept clean from dust, broken glass and other mounting media residues. Slide loader will
only operate safely and properly, if magazines are clean.
