33
32
3DISON H700
User Manual V.1
3DISON H700
User Manual V.1
Annex2. Extra Features
(Laser Engraver / WiFi Camera / Embedded Battery)
Laser Engraver
With this laser engraver, it is possible to cut off a thin wood or acrylic board what you design
in 3D modeling tool. Before you start installing using this laser engraver, please make sure to
be EXTRA PRECAUTIOUS when handling the laser engraver.
1. How to install
(This symbol stands for warning in using lasers.)
①
Power must be off before installation for your
safety.
②
Separate the existing extruder connector and
PCB connector.
③
Release connecting two bolts between the noz-
zle mount and the existing extruder using a hex
wrench and then separate.
④
Assemble the laser mount in the right direction
on the separated nozzle mount and fix it using a
connecting bolt.
Laser Engraver
⑥
Switch on power after connecting the laser
connector to the PCB connector.
⑤
Insert the laser nozzle bar into the laser mount
and fix it.
WARNING : Do NOT disassemble the laser mounted in the aluminum socket. This is de-
signed for user’s safety. A laser is a light source that can be dangerous to people exposed
to it. Even low power lasers can be hazardous to a person’s eyesight.
NOTE : Before exchanging the existing extruder, please make sure that the hot end reaches
the printing bed.
1. How to use
①
Put the plywood or acrylic plate to cut on the
printing bed of the printer.
②
Perform 3D modeling for the shape to cut in line
of 0.4mm width and store the 3D modeling in STL
file format.
The height of the object on 3D modeling should be
1 mm.
NOTE : In using this laser engraver, it is possible to
cut a maximum 3 mm-high acryl and a maximum
2 mm-high plywood.
Annex2. Extra Features
(Laser Engraver / WiFi Camera / Embedded Battery)