page
10
... print your plane | www.
3DLabPrint
.com
option B Factory files Simplify3D:
We prepared all you need in these files (FFF process settings, parts layout on bed, etc...)
You can use these settings as a start point. Adjust according to your need (adapt for your
printer), print single parts and so on... Most 3d printers should work just with these settings,
but please go through the settings and amend if necessary, we are not liable for any damage
resulting from using our settings. If this still does not work for you, please proceed to the
next option.
option C Prusa Slicer 3mf files (recommended)
Please follow the guide in the Help section of our website about
. At the
time of publishing this guide you need to
download the latest 2.4-beta version
from the
as previous stable version doesn’t support the Even/Odd slicing mode
yet. Don’t worry, it won’t interfere with your installed stable version as it lives in a separate
workplace.
Drag and drop the 3mf file to the Prusa Slicer window and open it as a Project. It will create
a Generic 3DLabPrint printer, printing profile and materials. Please use these as a starting
point instead of your printer profiles provided by your printer manufacturer. Strong thin-
wall printing is a different discipline than printing Benchys what are the stock profiles usu-
ally optimized for. Once you tweak your profiles (retractions, etc.) you can easily switch the
profile everytime you open the 3mf file. All the slicing tweaks, such as added top/bottom
layers etc. are stored in the models below, so it won’t be overwritten.
Remember: We are using 0.5 multiplier and 0 retraction with LW-PLA.
3MF
