Installation
3Dlabs Graphics Accelerator Card User's Manual
6
3.
If your board contains either two VGA connectors or two DVI connectors (or two
of each), you must always connect your first or only monitor to the connector
marked “1” and then you can connect your second monitor (if used) to the
connector marked “2”.
Attaching a Stereo Device
If your 3Dlabs Graphics Accelerator Card supports stereo viewing connect the stereo
hardware to the round, stereo connector on the card. See the documentation that
came with your stereo hardware. Plug in and start up your system, including
peripherals, and log on to your operating system.
Stereo viewing can also be supported
on boards without stereo connectors. An example of this is VX1-Stereo which uses a
dongle attached to the VGA connector.
1
2
1
2
VGA
connector
s
DVI
connectors
DVI
connectors
for flat panel
displays
Stereo
connector
3-Pin
Minidin
Stereo
Connector
Summary of Contents for Oxygen GVX1 Pro
