Copyright
2000 3Dlabs, Inc. All rights reserved. This document contains information protected by copyright, trade secret, and trademark law.
This document may not, in whole or in part, be reproduced in any form or by any means, or be used to make any derivative work,
without written consent from 3Dlabs, Inc.
Use, duplication, or disclosure by the United States Government is subject to restrictions as set forth in subdivision (c)(1)(ii) of the
rights in technical data and computer software clause at DFARS 252.227-7013. Unpublished rights are reserved under the copyright
laws of the United States.
3Dlabs Inc, 480 Potrero Avenue, Sunnyvale, CA 94086
Notice
Information in this document is subject to change without notice and should not be considered a commitment by 3Dlabs, Inc. 3Dlabs,
Inc. shall not be liable for technical or editorial errors in, or omissions from, this document. 3Dlabs, Inc. shall not be liable for
incidental or consequential damages resulting from the furnishing or use of this document.
All warranties given by 3Dlabs, Inc. about equipment or software are set forth in the warranty statement included with your product.
Nothing stated in, or implied by, this document or its contents shall be considered or deemed a modification or amendment of such
warranties.
Trademarks
3Dlabs, Inc. and Wildcat are registered trademarks of 3Dlabs, Inc. SuperScene and DirectBurst are trademarks of 3Dlabs, Inc.
Microsoft, the Microsoft logo, Windows, Windows NT, and Windows 2000 are registered trademarks of Microsoft Corporation. Intel
and Pentium are registered trademarks of Intel Corporation. OpenGL is a registered trademark of Silicon Graphics, Inc.
Other brands and product names are trademarks of their respective owners.
FCC/DOC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, try to correct the interference as follows: re-orient or relocate the affected device; increase the separation between this
equipment and the affected device; connect this equipment to an outlet on a circuit different from the circuit to which the affected
device is connected; consult a dealer or an experienced radio/television technician for help.
Changes or modifications made to the system that are not approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil
numérique de la classe B respecte toutes les exigencies du Règlement sur le materiél brouilleur du Canada.
Warnings
Changes or modifications made to the card that are not approved by 3Dlabs could void the user's authority to operate the equipment.
To reduce the risk of electrical shock, do not attempt to open the equipment unless instructed. Do not use a tool for purposes other
than instructed.
There are no user serviceable parts in the card. Refer all servicing of the card to qualified service personnel.
To comply with FCC Class B limits, you must use shielded cables with this device.
P/N 62-000006-001
Summary of Contents for The Wildcat 4110 PRO
Page 22: ...16 Figure 5 Wildcat 4110 PRO Stereo Output Port ...
Page 23: ...17 ...
Page 34: ...30 ...
