THERMAL GIMBAL FOR 3DR SOLO MANUAL
PWM Setup
12
ASSIGNING PWM FUNCTIONS:
In this section we will show how to:
•
Assign and configure PWM Functions in the FLIR VUE PRO/PRO-R App
FLIR VUE PRO/PRO-R Modification:
Without the modification, the FLIR VUE PRO & VUE PRO-R will only allow for Stabilized Video and Tilt
Control. Recording from the camera to the SD card will not be available from the 3DR Solo App.
See Page 3 for more information regarding the modification.
PWM Settings
These setting changes should be performed prior to flight.
NOTE: Before you begin, be sure that the settings are set to the following suggested values.
PWM's cannot share the same configuration.
If channels 3 & 4 are enabled, they will need to be set to "
DISABLED"
before
configuring PWM 1 & 2.
Open the FLIR VUE PRO App on your mobile device and
enter the settings panel.
Select the
ACCY. PORT
Tab.
Touch on the Serial Protocol drop down and select:
PWM
(Fig. 23)
Next we will define the parameters for the FLIR VUE PRO/
PRO-R to operate with the 3DR SOLO APP.
Select Channel 1:
This will open the configuration screen for Channel 1.
(Fig. 24)
