Stereoscopic TV System Users Guide
3DTV Corporation
www.3dtv.jp www.3dmagic.com
1863 Pioneer PKWY.E.142.Springfield, OR 97477 USA
seeall3d@yahoo.com
1
3D TV System Users Guide-For CRT Tube Type TV’s
This system will not work on LCD TV’s!
Please follow these steps to properly install, configure, and operate your system.
Hardware Setup
1)
Turn off the power to all of your electronic equipment before starting installation (TV, VCR, DVD, etc).
2)
Disconnect your RCA VIDEO cable (typically the cable with the yellow ends) connection between your source (DVD or VCR) and your TV. Leave this cable
plugged into the TV-disconnect it from your VCR or DVD source.
3)
Using the supplied RCA splitter cable, connect one male end to the “Video Out” line of your DVD or VCR source. Connect the other male end to the back of the
sync box. Connect the female end to the TV using the cable from Step2.
4)
Connect the battery in the sync box. This battery is included. But not plugged in during shipping.
5)
Press the power button to turn the system on if it does not come on initially.
Connecting the System to Your TV
