3e-525A Wireless Access Point
78
29000132-001 A
Chapter 5: Configure as bridge
29000132-001 A
79
The following sections describe the setup for three types of bridging
configuration: point-to-point, point-to-multipoint, or, lastly, repeater.
Setting Up Bridging Type
Point-to-Point Bridge Configuration
A point-to-point link is a direct connection between two, and only
two, locations or nodes. Because the bridge function uses a separate
WLAN card for bridging, you can also set up WLANs on the separate AP
WLAN card.
��������
��������
������ �
������ �
���������
���������
���������
For the two bridges that are to be linked to communicate properly,
they must be set up with compatible commands in the setup screens.
For instance, the bridges must have the same channel number. Be-
cause there is a separate WLAN card for bridging, there can be a separate
WLAN on the AP WLAN card with no loss efficiency, as long as you set
the channel numbers so there's no conflict or noise with the channel as-
Summary of Contents for 3e-525A
