Ver 1.0.0.0
Since 1988
3
4. Software Connection Settings
Refer to the following sections to set up the FWT Wifi AP_USB x 4. Before the setup, please
confirm that the LAN port of the AP has been connected with the PC via RJ-45:
y
Set up 3G Settings for the FWT Wifi AP_USB x 4
1. Please connect your computer to the FWT Wifi AP_USB x 4’s LAN port.
2. Initiate your Internet Explorer, and type in the address “10.10.10.254”
3. Please
input
“admin”
as the user name and the password. Click
OK
button to enter
AP’s setup page.
4. Once you are in the setup page, please select “
Internet Settings
” and enter “
WAN
”
section of the setup.
5. In the WAN MODE SETTINGS, please select the desired WAN connection type and
require the necessary information from your ISP once the STEP 3 in Section 2 is
configured.
6. As to 2G/3G ISP SETTINGS, please also contact your ISP for the dialup settings. User
must enter
Access Point Name (APN)
,
Dial Number
,
Username
and
Password
.
NOTE: The user must enter the PIN code by clicking on the
Management / SIM
function if you had set up before
for the SIM card.
Please ask your ISP for
required information
