SEITE 4 - 148 x 210 mm - 44000737039/03 - SCHWARZ - 11-249 (sr)
4
Remove the fuse unit from the device.
Press the catch lightly in an upward direction so that the
fuse holder can be pulled out. Remove the fuse from the
fuse holder and replace with a new fuse.
up special disposal facilities to handle the equipment.
Details about the procedure for the specific country can
be obtained from the pertinent 3M ESPE subsidiary.
10.3 Meaning of the Symbols
The EU Directive prohibits the
disposal of any electric or
electronic devices marked with
these symbols in combination
with household waste.
11. Customer Information
No person is authorized to provide any information that
deviates from the information provided in this instruction
sheet.
11.1 Warranty
3M ESPE warrants this product will be free from defects
in material and manufacture. 3M ESPE MAKES NO
OTHER WARRANTIES INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. User is responsible for
determining the suitability of the product for user’s
application. If this product is defective within the warranty
period, your exclusive remedy and 3M ESPE’s sole
obligation shall be repair or replacement of the 3M ESPE
product.
11.2 Limitation of Liability
Except where prohibited by law, 3M ESPE will not be
liable for any loss or damage arising from this product,
whether direct, indirect, special, incidental or conse -
quential, regardless of the theory asserted, including
warranty, contract, negligence or strict liability.
Information valid as of July 2011
Catch
Fuse holder
Attention: Use only fuses with identical ratings.
Insert the fuse holder in the fuse unit until the catch
audibly locks in place, then replace the fuse unit in the
device. Make sure that the bracket of the fuse unit points
towards the power switch of the device.
9.2 Care
Clean all components with a soft cloth and, if necessary,
a mild cleaning agent (e. g. dish-washing detergent).
Solvents or abrasive cleaners may not be used in any
case, as they can damage the plastic components!
- Cleaning agents must not enter the unit!
To disinfect all components, spray the disinfectant on
a towel and use it to disinfect the unit. Do not spray the
disinfectant directly on the device.
- Disinfectant agents must not enter the unit!
- Dry residual disinfectants on the device with a soft and
fluff-free cloth, as they damage the plastic components.
If necessary, ask the manufacturer of the disinfectant if its
constant use will damage plastic surfaces.
10. Return of Old Electric and
Electronic Equipment for Disposal
10.1 Collection
Users of electric and electronic equipment are required to
collect their old equipment separately from other waste in
accordance with the regulations of the specific country.
Old electric and electronic equipment must not be
disposed of with unsorted household waste. This separate
collection is a prerequisite for recycling and reprocessing
as an important method for preserving environmental
resources.
10.2 Return and Collection Systems
When your CapMix is no longer usable, do not dispose
of the device with household waste. 3M ESPE has set
