10
11
3
Relieve the pressure from the spray
gun and cup before servicing.
1. Turn off the air supply to the
spray gun.
2. Disconnect air line from the
spray gun.
3. Pull trigger to return mix to spray
gun cap.
General System Maintenance
Do not immerse the spray gun in solvent.
Spray Gun Care and Cleaning
Do not wipe the spray gun with a cloth
soaked in solvent; ring out the excess.
Note: Your spray gun may be made
from aluminum and may contain
aluminum components.
Certain
solvents containing Methylene
Chloride and Tricloromethane are
not chemically compatible with
aluminum.
Read, understand and follow all
safety statements as well as wear
appropriate, approved personal
protective equipment per the
applicable MSDS and material
container labels for cleaning
solutions.
You must lubricate the moving
components after every cleaning of the
spray gun. Cleaning washes away the
lubricants that protect the friction points.
Use an appropriate lubricant such as
petroleum jelly.
Do not use metal tools to clean the air
cap holes as this may scratch them;
scratches can distort the spray pattern.
Do not point the spray gun up while
cleaning it.
Lubricate
Lubricate
Lubricate
HVLP
Lubricate
Fig. 2
Fan Adjustment Knob
Adjusting the Fan Pattern Size
The fan size is regulated by the fan
adjustment knob as noted in Fig. 2.
As a starting point, gently turn the
knob clockwise until you feel no
further adjustment. Next, turn the knob
counter-clockwise one full rotation. The
fan adjustment will allow you to spray
from a small round to a full fan pattern.
The pattern can also be changed from
vertical to horizontal by rotating the air
cap a ¼ turn.
General Set Up and Spray Gun Use cont.
WRONG
RIGHT
Spray Technique
1. To achieve the best results when
spraying material, keep the spray
gun perpendicular to the surface and
maintain a consistent distance of
approximately 6 to 8 inches
(160-200 mm) from the object being
sprayed.
2. Use smooth, even strokes across the
surface to be sprayed with 50% over-lap.
3. Paint using parallel strokes. This
technique applies all coatings evenly
without cross coating.
Horizontal Pattern
Vertical Pattern
Right
90º
6” - 8”
Note:
The small round pattern can
be achieved by closing down the fan
adjustment, triggering the gun lightly,
and maintaining a distance from your
target of 2 to 4 inches (50-100 mm).
Summary of Contents for 10
Page 33: ...62 Nota...